Ericsson MINI-LINK CN 210 1.1MINI-LINK Enterprise & Carrier Solutions
CN is a compact and easy to install microwave transmission node built
with simplicity in mind. MINI-LINK CN is optimized for end sites, single
hops, and enterprise networks. There are a number of MINI-LINK CN
products, MINI-LINK CN 210, MINI-LINK CN 500 and MINI-LINK CN 510, each
of them specifically optimized for a certain type of site.
MINI-LINK CN is Hop compatible with MINI-LINK TN & MINI-LINK PT 2010
MINI-LINK CN is used in a number of different scenarios:
CN provides up to gigabit capacity at telecom grade availability. with 1
Gbps over the hop, MINI-LINK CN supports the capacities required by
LTe. our best in class radio output power provides longer hops with
roll-out of mobile backhaul networks; in mobile backhaul networks
MINI-LINK CN is a perfect fit at the access site with MINI-LINK TN on
the other side of the hop, at the aggregation site, supporting the
packet network end to end.
of mobile backhaul networks; MINI-LINK CN supports Native ethernet as
well as Native TDM and a mix of them. This enables our customers to
start with TDM traffic, add ethernet when data traffic increases, and
move to all ethernet when required. MINI-LINK CN can be a perfect
upgrade of MINI-LINK e at end sites.
Broadband over Microwave; connecting Enterprises or rural areas to
existing transport networks with microwave is a well proven cost
Broadcasting and National security customers can successfully deploy
both single hops, and complete backhaul networks.
Handling your IP network evolution MINI-LINK
CN supports any network scenario; both new packet-only networks as well
as evolutions from TDM to packet. It fully supports carrier grade
networks with Native ethernet and carrier-grade qoS for ethernet, IP as
well as MPLS and sync distribution in packet networks.
CN also provides Layer 1 sync distribution to your existing network and
introduces no extra delay or delay variation. MINI-LINK CN is a complete
solution for the evolution of your network.
The Hybrid radio
Link transports both Native ethernet and Native PDH simultaneously over
the same hop, which is perfect for a cost-effective TDM to packet
migration. Start with all e1s or a mix with ethernet. Add more ethernet
as data traffic increases and complete the migration by moving to
all-ethernet. MINI-LINK CN Radio Unit (RAU2 X)Saves cost
CN is a Cost Saver; it is compact and easy to install. The all-outdoor
solution speeds up and facilitates roll out even further with no need
for a site building.
Existing MINI-LINK customers can save time, money, space and reduce upgrade risks by reuse of the installed base.
Native ethernet at end nodes by replacing MINI-LINK E with the space
optimized MINI-LINK CN, without replacing the actual outdoor units, nor
the cabling to the outdoor units.
The market leading reliability of MINI-LINK includes a field proven MTBF of typical over 70 years.Network Synchronization
MINI-LINK CN 500 supports transport of synchronization signal across the hop.
The synchronization signal is carried over the radio hop without occupying any bandwidth allocated for payload traffic.
regarding delay performance, delay per link for Priority traffic is <0.8 ms for radio link (TDM and Packet) capacities below 50 Mbit/ s and <0.5 ms for radio link capacities above 50 Mbps. Delay variation for priority traffic is <0.5 ms per link.
Hybrid Radio Link
Native ethernet and Native PDH are supported over the microwave radio link. The maximum net rate over one radio is up to 400 Mbps per radio. © Ericsson - All pictures